JUMBO DISPLAY
DUAL ALARM CLOCK RADIO
MODEL CR-777
OPERATING INSTRUCTIONS
DUAL ALARMS - PERFECT FOR WEEKDAYS
•
& WEEKENDS
EASY TO READ JUMBO CLOCK DISPLAY
•
WAKE UP TO RADIO OR ALARM
•
AM/FM RADIO RECEIVER
•
ELECTRONIC DIGITAL CLOCK
•
PM & DUAL ALARM INDICATORS
•
SNOOZE FUNCTION(FOR EXTRA 7 MINUTES SLEEP)
•
SLEEP TO RADIO (WITH AUTOMATIC SHUT OFF)
•
BATTERY BACK-UP (9V BATTERY, NOT INCLUDED)
•
PLEASE READ CAREFULLY BEFORE USE
IB-CR777(NL)-WM-E-020504
ADDITIONAL SAFETY INSTRUCTIONS
1. Power Sources - The appliance should be connected to a power
supply only of the type described in the operating instructions or
as marked on the appliance.
2. Wall or Ceiling Mounting - The appliance should not be mounted
to a wall or ceiling.
3. Object and Liquid Entry - Care should be taken so that objects
do not fall and liquids are not spilled into the enclosure through
openings.
4. Servicing - The user should not attempt to service the appliance
beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
5. Do not connect FM antenna wire to any outdoor antenna.
LOCATION OF CONTROLS
FRONT VIEW
ALARM SET
ALARM 1
INDICATOR
SWITCH
TUNING
CONTROL
(1, 2 or 1+2)
CLOCK DISPLAY DIAL SCALE
DIMMER
SWITCH
ALARM 2 INDICATOR
PM INDICATOR
VOLUME
CONTROL
TOP VIEW
SNOOZE
BUTTON
FUNCTION SWITCH
(BUZZ/AUTO/OFF/ON)
BAND
SWITCH
FORWARD
BUTTON
SLEEP
BUTTON
TIME SET
BUTTON
ALARM/SLEEP
OFF BUTTON
REVERSE
BUTTON
ALARM
BUTTON
IB-CR777(NL)-WM-E-020504
2
LOCATION OF CONTROLS
BACK VIEW
BATTERY
COMPARTMENT
(9V, for back up)
FM ANTENNA WIRE
AC POWER CORD
(unwind for best reception)
OPERATING INSTRUCTIONS
Powering Up
Plug the AC power cord into a 120V, 60Hz electrical outlet. The clock
display will light up and flash indicating the power is on.
NOTE: This cord is polarized. This means the cord will only fit one
way into the socket or wall outlet. If it does not fit, do not force
it, just reverse it and try again.
BATTERY BACK-UP
If the AC cord is disconnected or if there is a short time power failure,
this electronic clock and timer are designed to continue operating
internally (without showing the time in the display) if a 9 volt battery (not
included) is installed.
The radio will work fine without this backup battery.
NOTE: You may check the condition of the battery every few months
by disconnecting the AC cord and connecting it again 2 or 3
minutes later. The preset times will show. If the time flashes, it
indicates the battery is dead or not connected properly.
Setting the Clock
1. Press and hold the TIME set button together with the FORWARD
button until the display shows the desired hour.
2. Press and hold the TIME set button together with the REVERSE button
until the display shows the desired minutes.
NOTE: When the PM indicator is off, the time is AM.
3
OPERATING INSTRUCTIONS
Setting the Alarm Times
This set has dual alarms. You may set ALARM 1 to wake you at a certain
time, or ALARM 2 to wake you at a different time, or ALARM 1+2 - both
alarms will sound at the times you set.
This feature is useful for a husband & wife waking up at different times
or a single person who likes to wake up at different times during week
days or weekends.
To set ALARM 1, slide the ALARM SET switch to position 1.
To set ALARM 2, slide the ALARM SET switch to position 2.
1. Use the ALARM button to check the alarm time.
2. Press and hold the ALARM button together with the FORWARD button
until the display shows the desired alarm hour time.
3. Press and hold the ALARM button together with the REVERSE button
until the display shows the correct alarm minutes.
4. Make sure the PM lamp is off if you want the clock to wake you in the
morning.
5. Release the ALARM button, the clock display will show the normal
time of day. Press the alarm button to display the alarm time.
NOTE 1:Again check the PM indicator. If you want the radio to
wake you in the morning, the lamp above to PM should
be off on alarm time (when pressing ALARM button). To change
PM to AM time, advance time 12 hours.
NOTE 2: To wake to ALARM 1 time, slide ALARM SET switch to position 1.
To wake to ALARM 2 time, slide ALARM SET switch to position 2.
To wake to both times, slide ALARM SET switch to position 1+2.
Playing the Radio
1. Slide the FUNCTION switch to ON position.
2. Slide the BAND switch to either AM or FM.
3. Turn the TUNING control to your desired station.
4. Adjust the VOLUME control to your favorite listening level.
5. Slide the FUNCTION switch to OFF position to shut off the radio.
GETTING BETTER RADIO RECEPTION:
For best AM reception, rotate the radio a small amount or position it
near the window.
For best FM reception, unwrap and fully extend the FM antenna wire.
WARNING: Do not connect the FM antenna to an outdoor antenna.
Waking up to Radio (Alarm)
1. Set the alarm time as previously instructed and slide the ALARM
SET button to ALARM 1, ALARM 2 or ALARM 1+2.
2. Select your desired AM or FM broadcast by following the procedure
of Playing the Radio.
3. Make sure the VOLUME control is set loud enough to wake you up.
4. Slide the FUNCTION switch to AUTO position and the ALARM 1,
or ALARM 2 or both indicators will light up (depending on what you
select on step 1).
NOTE: Your set is now ready to turn on automatically at your
selected alarm time(s).
5. When alarm sounds, to get 7 minutes of extra sleep, press the
SNOOZE button.
6. To shut off the alarm, press ALARM/SLEEP OFF button.
IB-CR777(NL)-WM-E-020504
4
OPERATING INSTRUCTIONS
Waking up to Buzzer (Alarm)
1. Set the alarm time as previously instructed and slide the ALARM
SET button to ALARM 1, ALARM 2 or ALARM 1+2.
2. Slide the FUNCTION switch to BUZZ position and the ALARM 1,
or ALARM 2 or both indicators will light up (depending on what you
select on step 1).
3. The buzzer alarm is now set to turn on automatically at the
selected alarm time(s).
4. When buzzer sounds, to get 7 minutes of extra sleep, press the
SNOOZE button.
5. To shut off the alarm, press ALARM/SLEEP OFF button.
Snooze Control
When this set has waken you up and you wish to sleep a few minutes
more, simply press the SNOOZE button. The radio or buzzer will go off
for 7 minutes and then come on again. This is repeated in a row.
Alarm Off
1. Press ALARM/SLEEP OFF button. This will shut the alarm for that
day only. Next day the set will wake you again at the same time.
2. Slide the FUNCTION switch to OFF position and the alarm function
is off until you re-adjust the FUNCTION switch to AUTO or BUZZ.
Sleep Control
The SLEEP control will allow the radio to play 59 minutes before the
radio turns itself off.
1. Slide the FUNCTION switch to BUZZ or AUTO position.
2. Press the SLEEP button, the display will show 59 minutes
and the radio will start to play.
3. Press the SLEEP button down together with the FORWARD or
REVERSE button until the display shows your desired amount of
time you want the radio to play before shutting itself off.
4. Release both buttons. The radio will play for the time you selected
and shut itself off.
5. To turn the radio off before the playing time has expired, simply press
the ALARM/SLEEP OFF button.
NOTE: The sleep function will not affect the wake-up operation of the
clock if the FUNCTION switch is in AUTO or BUZZ position.
In the morning, the radio or buzzer will wake you up if FUNCTION
switch is in the AUTO or BUZZ position.
Display Dimmer
The clock display has 2 settings: HIGH and LOW. Slide the switch to
adjust the brightness of the display.
IB-CR777(NL)-WM-E-020504
5
TROUBLE SHOOTING
(Helpful Hints)
SHOULD YOUR SET EXHIBIT A PROBLEM, CHECK THE
FOLLOWING BEFORE SEEKING SERVICE.
SYMPTOM
CAUSE
SOLUTION
AM or PM not set
correctly. Is alarm
time set in AM range
(PM Lamp off)?
Advance the clock 12
hours.
FUNCTION switch is
in OFF position.
Set the FUNCTION
switch to AUTO or BUZZ
position.
Alarm does not
come on in the
morning.
Are the ALARM
INDICATORS off?
Recheck the ALARM 1 &
ALARM 2 times, and make
sure the proper ALARM
indicator is turn on.
ALARM SET switch is
not in the proper
position.
FM antenna wire
is not extended.
Extend FM antenna
wire.
FM is distorted
and weak.
Station not tuned in
properly.
Tune to desired
station carefully.
Turn to a stronger
station.
Weak broadcast
station.
Rotate the set to receive
better signal.
Signal is blocked.
Noise or weak
sound on AM
broadcast.
Turn the radio for better
AM reception or bring set
near a window.
External
interference.
Slide the FUNCTION
switch to ON position.
FUNCTION switch is
in the OFF position.
Radio no
sound.
VOLUME control set Rotate VOLUME control
to minimum position. for desired sound.
Set the clock and alarm
The clock is not set.
time.
The clock is
flashing.
A power failure has
occurred.
Reset the clock alarm time
and time of the day.
Connect set’s AC cord
and make sure outlet has
power.
The set’s AC cord is
Clock is dead.
not connected.
LENOXX reserves the right to make design and specification changes
for product improvement.
PROTECT YOUR FINE FURNITURE!
WE RECOMMEND
A
CLOTH OR OTHER PROTECTIVE
MATERIAL BE PLACED UNDER THE SET WHEN PLACING IT
ON SURFACE WITH A NATURAL OR LACQUER FINISH.
IB-CR777(NL)-WM-E-020504
6
SPECIFICATIONS
Power source:
AC 120V, 60Hz, 8W
DC 9V battery for backup time memory
(optional, alkaline battery is recommended)
Dimensions:
9" (Length)
4 1/4" (High)
2 3/4" (Depth)
Frequency range: FM 88 - 108MHz
AM 530 - 1700kHz
LIMITED WARRANTY
We warrant this product to be free from defects in material
and workmanship under normal use for a period of 90 days
after purchase and we will repair it free of charge or replace
it at no charge, should it become defective under this
warranty, providing you submit proof of purchase (sales slip)
with the set.
During the initial 90 day period after original purchase, we will
service or exchange, at no charge, the set that is returned to
LENOXX ELECTRONICS CORP. After the initial 90 day period
expires, and for a period of 12 months from original purchase, we
will repair the unit covering any part(s) that need to be replaced at
no charge, but will charge for the cost of labor, return postage paid
by LENOXX.
This warranty does not apply to any products which have been
subject to misuse, neglect or accident. This warranty does
not cover broken cords or cabinet. UNDER NO
CIRCUMSTANCES WILL LENOXX ELECTRONICS CORP. BE
LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. The following
charges apply to repairs beyond the warranty period: $5.00. Be
sure to pack carefully and return postage paid insured together with
your money order (personal checks will not be accepted) and sales
receipt to :
LENOXX ELECTRONICS CORP.
2 GERMAK DRIVE, CARTERET N.J. 07008
For customer service
Dial 1-800-315-5885
(MONDAY - THURSDAY 9:00 AM - 5:00 PM, FRIDAY 9:00 AM - 1:00 PM EST)
© 2003 LENOXX ELECTRONICS CORP.
2 GERMAK DRIVE
CARTERET, N.J. 07008
MADE & PRINTED IN CHINA
IB-CR777(NL)-WM-E-020504
7
|